Conveyor belt joint method
When you feel that it is not sticky and sticky, where there is a tape joint, the two rubber faces should be bonded from the middle to the sides to squeeze out the air. Knocking with a hand
Bond the surface and bond it. Then use a steel plate to compact and cure, the longer the better. Good aviation adhesive, after sticking
You can drive in 20 minutes, but it is better to put 3h.
Comparison of several methods for conveyor belt bonding joints
There are two types of conveyor belt bonding. Cold bonding and hot vulcanization bonding. The strength of these two joints can reach 80-90% of the conveyor belt; the mechanical joint strength is only 60-65%. And this
The type of connection does not leak the belt joint company, it is not easy to tear and not easy to hurt the drum. But these two methods also have their own advantages and disadvantages.
Cold-adhesive: The advantage of bonding speed is short, the cost is low, and the position is better. Disadvantages are very demanding on the environment Steel ribbon joints, such as rain and snow, dust, adhesives are greatly affected by temperature. Durability is not as long as hot tack.
