Address: NO.45, Zhennan 7th RD, Tongan District, Xiamen City, China.
FAX : +86-592-5144207
Light conveyor belt connector
Conveyor belt joints can be applied to all methods, but generally use toothed heat fusion joints, in this way the joints will be very strong, if special requirements can be used steel buckles and laps.
Rubber conveyor belt connector
Rubber joints generally use vulcanized joints.
Synchronous belt connector
The timing belt joints are only toothed joints and seamless joints. When the teeth are connected, it is necessary to pay attention to the complete match between the tooth surface of the timing belt and the other end. Otherwise, it will be impossible to use and match the mold of the matching model when hot jointing.
The seamless joint is a timing belt that is integrally formed without any joints, and uses a seamless timing belt to provide greater strength and firmness than the teeth.
Another use of timing belts is the use of openings, one of which is fixed with a matching abrasive tool.
In addition to the regular use of the timing belt, various types of stoppers can be added to the surface of the timing belt!
There is only one type of connection for the baseband, oblique lap
1. Cut oblique bevels, sanding, and glue at the opening
2. The interface is spliced and the device is hot pressed
3, the joints are polished
Round band connector
There is only one type of connection for the round belt, hot connection
4, cut neatly at the opening
5, interface splicing, on the device hot pressing
6. Grinding and trimming at the joint